need instructions for greddy turbo timer
06-30-04, 02:17 AM
#1
You've Been Punk'd
Thread Starter
Join Date: Jun 2002
Location: Branson, Missouri
Posts: 4,727
Likes: 0
Received 0 Likes
on
0 Posts
need instructions for greddy turbo timer
i got a turbo timer with an fc harness but no directions. i need the manual. can somone help?
number gtt3 27139
number gtt3 27139
06-30-04, 02:18 PM
#3
Senior Member
Join Date: Jul 2003
Location: san diego, ca
Posts: 360
Likes: 0
Received 0 Likes
on
0 Posts
to install or to use the timer. I can take pics of the harness installed. I also have the manual if you need any help. you can aim me at ekenrique later tonight when I am at home.
06-30-04, 02:54 PM
#4
You've Been Punk'd
Thread Starter
Join Date: Jun 2002
Location: Branson, Missouri
Posts: 4,727
Likes: 0
Received 0 Likes
on
0 Posts
i just need the install instructions, which wires go where etc. thanks ill be on later tonight around 9:30 my time (central) until late (7:30 yours)
06-30-04, 03:07 PM
#5
Seduced by the DARK SIDE
Join Date: Apr 2001
Location: Orange Park FL (near Jax)
Posts: 7,323
Likes: 0
Received 2 Likes
on
2 Posts
My HKS timer has yet to work.
All hooked up - fails to latch on.
Beware of aftermarket installed & removed alarm systems. (total rat's nest by my left foot)
All hooked up - fails to latch on.
Beware of aftermarket installed & removed alarm systems. (total rat's nest by my left foot)
06-30-04, 03:31 PM
#6
Boosting Again
www.greddy.com they have all the instructions on there website, under technical section. its not that hard to connect, go under dash and unplug 2 connectors that look like the ones on greddy turbo timer harness then connect them, if it doesnt work try it other way arounnd, i got mine to work this way. i didnt need the instructions
Trending Topics
06-30-04, 08:54 PM
#9
I R SAD PANDA W/O BAW
For my blitz TT it was pretty straight forward. The harness should have 4 plugs (2 sets) I believe and I dont think you can mess that up. There are 2 sets of plugs that match the ones on the harness under the steering column, unplug those and connect them with the harness plugs. Then there should be 3 more wires. 1 ground, 1 power and 1 for the ebrake sensor. Normally the ground will be black and the power could be yellow or red usually. The ebrake sensor must be installed or it will not keep the car idling. It is under the center console (in front of the armrest). IIRC it was a red wire that needs to be spliced into. That's it.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
