Need help w/intake porting
Thread Starter
Full Member
Joined: Jun 2006
Posts: 113
Likes: 0
From: Hampton Va
Need help w/intake porting
Ok so I am trying to port my intake on my s4 NA. I have read all the FAQs but its hard to do with out the pics.
Can someone/anyone put up a site with the pics or post some of them on this thread.
I really need this. thanx for the help.
Can someone/anyone put up a site with the pics or post some of them on this thread.
I really need this. thanx for the help.
Seduced by the DARK SIDE
Joined: Apr 2001
Posts: 7,323
Likes: 2
From: Orange Park FL (near Jax)
I made a rotor template with with a piece of clear plastic.
If you mark the corner & side seal positions on the template, you can see where NOT to cut.
You don't want the end of the side seal to drop into the port.
If you mark the corner & side seal positions on the template, you can see where NOT to cut.
You don't want the end of the side seal to drop into the port.
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
I think he means intake manifold...
If that's true, then don't waste your time unless you have already done everything else and you are very bored. I don't think anyone has ever shown any significant gains that didn't come from the "butt dyno". Icemark had good results with the ExtrudeHone process though.
If that's true, then don't waste your time unless you have already done everything else and you are very bored. I don't think anyone has ever shown any significant gains that didn't come from the "butt dyno". Icemark had good results with the ExtrudeHone process though.
Thread
Thread Starter
Forum
Replies
Last Post
iamsisyphus
2nd Generation Specific (1986-1992)
6
Sep 27, 2015 01:42 PM