Hey I am in desperate need of a Pinion Flange that will allow me to mate the T2 Driveshaft to the N/A rear end. I really need this piece bad for a good price so if someone has one help a fellow guy doin the T2 swap out....LOL. But if anyone has one or knows where I can get one then please EMAIL ME AT LIBB58@AOL.COM

I would greatly appreciate it, and I would also like some prices on some T2 rear ends you guys may have....I have spent all my money up but I wont be able to even drive my car hard for a while if I run with this N/A rear end w/a broke mount. With the mods I have I'm making about 250-280hp at 11-13lbs of boost and imagine pushing that, with a not only a weak N/A rear end...but one with a broke rear differential mount. So yeah my car is hot and the swap went great but I wont even be able to feel the power till either that mount is replaced or I put a T2 Rear end in. Man THIS REALLY SUCKS....but yeah if u cn offer any help PLEASE EMAIL ME AT LIBB58@AOL.COM
Thanks
Mike

 

There is no such thing.

Why not redrill your current flange to fit the different bolt pattern like almost everyone else does?


-Ted

 

Or if you want to spend some $$$, get a driveshaft made for the TII trans and a N/A rear. Mazdatrix I believe.

 

Will the auto driveshaft from a T2 work?

 

Nope, and make certain to check pg 2 out:
https://www.rx7club.com/showthread.p...threadid=81463

 

Thanks I guess I am stuck....and have no choice of goin with the T2 Rear end. Anyone got one for me....email me at Libb58@aol.com