Need Help Installing AVC-R??
Thread Starter
Full Member
Joined: Mar 2001
Posts: 91
Likes: 0
Need Help Installing AVC-R??
Ok, i'm installing a AVC-R on a 88 Turbo, I can't find where the speed sensing wire goes? I need help, I can't find the cruise control unit and am not sure where to put the speed sensing wire?? please help, everything else is connected and good to go....
thanks
thanks
Rotorhead
Joined: Feb 2001
Posts: 9,136
Likes: 39
From: Charlottesville, Virginia, USA
The cruise control unit is under the driver side dash by the CPU and fuse box. It is the metal box mounted to the inside of the fender panel. It has a white 13-pin connector stuck in the bottom.
The cruise control actuator is a large black box with a throttle cable-looking thing coming out of it. If you open your hood, you will see it mounted on the passenger side firewall.
The speed sensor is part of your wonderful Mazda all-in-one gauge cluster. When you remove the gauge unit from your dash, there are some wires hanging out of the back. The speed sensor wire is the green & red wire coming out of the big white round connector on the circuit board.
Sorry, no habla AVC-R, so I have no idea where your connections go.
The cruise control actuator is a large black box with a throttle cable-looking thing coming out of it. If you open your hood, you will see it mounted on the passenger side firewall.
The speed sensor is part of your wonderful Mazda all-in-one gauge cluster. When you remove the gauge unit from your dash, there are some wires hanging out of the back. The speed sensor wire is the green & red wire coming out of the big white round connector on the circuit board.
Sorry, no habla AVC-R, so I have no idea where your connections go.
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
Nov 10, 2018 12:03 PM
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM