Need help with horn wiring with aftermarket hub and quick release
#1
Need help with horn wiring with aftermarket hub and quick release
I can not get my damn horn to work through my hub and quick release...When i ground the wire coming from the turn signal cancel piece the horn works. I have hooked up the horn as directed like this:
and it will not work. I don't know what else to try. When i press the horn button through the hub and quick release I can hear a relay click but no horn.
and it will not work. I don't know what else to try. When i press the horn button through the hub and quick release I can hear a relay click but no horn.
#2
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
Is it the HORN RELAY in the CPU that you hear???? If so, then the hub assy is working and it's the lack of power thru the pulled in HORN relay inside the CPU that is giving you fits.
I'd help you further but I can see you cars interior is looking like new and mine does not so I'm not going to help you anymore. But my horn works! humor
I'd help you further but I can see you cars interior is looking like new and mine does not so I'm not going to help you anymore. But my horn works! humor
#3
the clicking sounds like its coming from the far left side of the car so it probably is the CPU...my battery very well could have been dead/dying as i was doing some other work for about an hour with the doors open and the battery still hooked up. i will let the battery charge for a little bit and go test it later. i could have swore i hooked it up correctly, it doesn't seem very complicated.
the pictures are from an NSX forum...
thanks hailers
the pictures are from an NSX forum...
thanks hailers
Last edited by 87 t-66; 06-01-10 at 07:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM