Need help with horn wiring with aftermarket hub and quick release
 

I can not get my damn horn to work through my hub and quick release...When i ground the wire coming from the turn signal cancel piece the horn works. I have hooked up the horn as directed like this:


http://www.chicagoz.com/DIY/DSC02000.JPG
http://www.chicagoz.com/DIY/DSC02001.JPG


and it will not work. I don't know what else to try. When i press the horn button through the hub and quick release I can hear a relay click but no horn. :wtf:

Is it the HORN RELAY in the CPU that you hear???? If so, then the hub assy is working and it's the lack of power thru the pulled in HORN relay inside the CPU that is giving you fits.

I'd help you further but I can see you cars interior is looking like new and mine does not so I'm not going to help you anymore. But my horn works! humor

the clicking sounds like its coming from the far left side of the car so it probably is the CPU...my battery very well could have been dead/dying as i was doing some other work for about an hour with the doors open and the battery still hooked up. i will let the battery charge for a little bit and go test it later. i could have swore i hooked it up correctly, it doesn't seem very complicated.

the pictures are from an NSX forum...

thanks hailers :icon_tup:

i know that interior.

my battery was dead...after charging it, the horn is nice and loud :D

thanks again hailers, this was driving me nuts.