need a gasket
#7
Sharp Claws
iTrader: (30)
you can make them easy enough: place the gasket on the pipe and tap around the perimeter with a hammer so it makes indentions of where the gasket lines up with the outer edge of the flange and cut out this portion. for the bolt holes and middle hole use a small socket and medium sized one and hammer it through the gasket, makes perfect holes.
Trending Topics
#10
Open up! Search Warrant!
Join Date: May 2002
Location: Kicking down doors in a neighborhood near you
Posts: 3,838
Likes: 0
Received 2 Likes
on
2 Posts
I got a couple from www.atpturbo.com but I don't have the stock turbo, its a Garrett. Not sure if the flange is the same between the two. This is mine in the picture.
Thread
Thread Starter
Forum
Replies
Last Post
matty
3rd Generation Specific (1993-2002)
40
10-06-15 09:13 PM