Lazieboy

I pulled into my driveway and I was parked and I went through my gears and then it just got stuck in first. But I was able to move the shifter around and put it into 4th, 5th and Reverse but it stayed in 1st. I hope it isn't the trans. because I just put one in there not to long ago. Any advice would be greatly appriciated.

Thank You
David

BlackRx7

sounds like the throw out bearing,,, or the bearings in the tranny...

Lazieboy

My Throw out bearing is fairly new prolly about 10,000 miles on it.

BlackRx7

well if you can't put it into 2nd or 3rd I'd say its the tranny...if not bump

ZachSpazz

It could have failed, due to lack of lubrication or defect. Was the transmission you put into your car used or a rebuild?

Aaron Cake

iTrader: (1)

Sigh....Do you mean that you can move the shifter to the 4th, 5th and Rev positions, yet when you let out the clutch it is still in 1st?

First thing to check is the shifter itself...Loose? Damaged?

If it's OK, you might be looking at a broken or bent shift fork, meaning internal transmission problems.

Rx-7Addict

iTrader: (2)

Try pushing the shifter right and then down


When shifter bushing wear out it appears to be stuck, but the bushings are just so worn out

WolfsRx7

iTrader: (1)

I had the same prob with mince cept it got stuck in reverse. and I was lookin at a vert so I think my baby was jealous. anyway I'll agree with aaron with the shift fork being bent or broke.