My 90 RX7 will not turn over/start. The starter itself is fine.
09-18-09, 09:04 PM
#28
Junior Member
Join Date: Feb 2008
Location: NorCal
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
FIXED!
Here is what I understand. There is potentially a break in the command wire from the ignition switch to the starter solenoid. The break is before the air control valve. (part of cold start feature?) So basically, when I installed the new wire, I just bypassed the break. Once it's connected to the other side of the broken wire, it will send signal to the BAC and everything will be back to normal.
Here is what I understand. There is potentially a break in the command wire from the ignition switch to the starter solenoid. The break is before the air control valve. (part of cold start feature?) So basically, when I installed the new wire, I just bypassed the break. Once it's connected to the other side of the broken wire, it will send signal to the BAC and everything will be back to normal.
Thread
Thread Starter
Forum
Replies
Last Post
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM
