hey i have a question on if any one would know the price if i were to go to the muffler shop and have them bend a pipe to replace my cat and pre cat...and just weld it in... has any one done this? or is there a cheap solution because i have some rusty *** cat and pre. i took the cat and pre out n jb weld as much as i could but still leaking so i need a new solution...if any one knows of a good deal or are sellin their exhaust please hit me up...thanx



soy

 

most muffler shops will not violate the federal law on removing emissions equipment.

 

well i'm in fl we dont even get smog check

 

Even though IceMark is right, that it's illegal to remove, a lot of little shops will do it for you. I had it done to my car for about 60 bucks, but my price included a piece of flexible muffler, about where the cats went. you could probably get that down a bit if you don't include that, but I liked the added flexibilty.

 

Here in NY we do have serious smog rules and I still got ti done without questions. the guy just told me "you know without this your not gonna be able to pass emissions" and I replied "I dont care please just do what im paying for". In all it cost me $200 to get a complete new set of pipes put on from my exhaust manifold back to my fake N1's, with a pre silenecer in place of the cat.

 

Here in MN it is exactly the opposite. We don't have any emissions testing and even the little shops won't do it.

 

http://rx7.com/store/rx7/FC25racepipe.html

Or, why not do it right?

http://rx7.com/store/rx7/superflo.html