ive done a search here bought found nothing anywase it was brought to my attention that it is possible to mate two 13b engines im just lookin for somemore information on this

 

When our powers combine they form 787B *cue captain planet theme song*

 

I think it can be done.....Well anything can be done as long as you have the dough. You will also have to get a custom eccentric shaft ($$$) and the obvious fuel mods and spacing mods (dont know if it would fit) if it did need custom engine mounts....

To much work

 

But in all seriousness check out 3rotor.com, last I heard they had a 4 rotor up on there.

 

I'd go with 3 rotor my self, good luck.

 

Also the Mazda LeMans winning race car was a 4 rotor. Look up some on that. Basically its going to be vary expensive to do, but if youve got the cash I saw go for it. Theres a guy on the first gen forum that is working on fabing up a 4 rotor to go into a first gen. Do a search for cheifasorousrex or something along those lines. Ill see if I can find a link.

 

BAM

https://www.rx7club.com/forum/showth...hreadid=137343

 

I have read that it takes about $50,000 in cash to mate 2 13Bs together to form the 4 rotor engine..

GL

 

not sure if its 13B's mated but its still bad ***...think it 2 12A's....

 

A 26b quad rotor. It will take some mass cash. They have them. Just think what it would be like to hold that custom e-shaft in your hand. $$$$$$$$$$$

 

Guys have mated two 13b's together! It can and has been done! I think some guys who did it had something to do with www.grannyspeedshop.com

 

Good GOD! that thing is HUGE! probably pumps out alot of friggin HP too!.. hope you got some good custom fabrication skills...

 

Wasn't there a British shop that had one on there web page??

 

You're probably thinking of Hurley Engineering. They've done everything from 1-6 rotor wankels. So has MVA Motorsports in Jersey. Pineapple Racing sells "ready-to-go" 4-rotors for $8500 USD which they claim make 850 hp in NA trim.

 

Sounds like time to start saving up...

 

Yeah, I think it would be cheaper to buy a 3 or 4 rotor than to make one by putting 2 12a's or 13b's together. You would have to have a nearly unlimited budget and mad fabrication skillz to pull it off in your garage. Chefasaurus is building one to attempt to break the land speed record in bonneville, Utah. He is having a custom made 4 rotor e-shaft built and he said they are $2000 each.

There was a 3 rotor 20B on sale on ebay last week for 2500. Its harder to get parts for those, but not impossible. They come up for sale fairly often, so maybe if you tore it down and rebuilt it you could still have massive amounts of power and still have $$$ left.

 

I think i just got a hernia from looking at that thing!!

 

Some place in australia had 4 rotor shafts for not a huge amount, i also saw a tractor pull car that had 2 13b's linked with a chain

 

I've heard that there is a guy in Tyler, Texas that build 4-rotor motors.

 

how about an engine in back and an engine in front Escudo type of deal, guess that wouldnt be possible in a 7 tho, and really expensive. lol