Lost my FSM CD need quick ID on 13b-T Hoses
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Nov 2002
Location: San Jose, CA
Posts: 312
Likes: 0
Received 0 Likes
on
0 Posts
Lost my FSM CD need quick ID on 13b-T Hoses
As some may Know my car was broken into an my FMIC, Intake, MAFS, seats and other parts were stolen......Im bringing the car back to stock for now (burglar's court date is coming up) but I have a Vaccuum leak somewhere and I can't remember WHAT went there and I can't find my FSM.......here are some of the pics:
I know this is a hose, but to WHAT?
I really can't remember what this went to....
..I hate this guy for ******* my **** up.....and I'm even more pissed because I can't find my FSM.
I know this is a hose, but to WHAT?
I really can't remember what this went to....
..I hate this guy for ******* my **** up.....and I'm even more pissed because I can't find my FSM.
#2
Lives on the Forum
iTrader: (8)
1) the hose goes between the IC and the valve. that's for the accelerated warmup.
2) your hand is blocking the view of where the hose comes from. The hose at the bottom of the bac valve should go to the intercooler pipe above the turbo. that's about all I can tell about it.
2) your hand is blocking the view of where the hose comes from. The hose at the bottom of the bac valve should go to the intercooler pipe above the turbo. that's about all I can tell about it.
#3
Banned. I got OWNED!!!
Thread Starter
Join Date: Nov 2002
Location: San Jose, CA
Posts: 312
Likes: 0
Received 0 Likes
on
0 Posts
can the car run without the accelerated warm up hose?
the second hose comes from the turbo pipe......one of the hoses on the turbo pipe is for my BOV and the other I'm holding in my hand........
the second hose comes from the turbo pipe......one of the hoses on the turbo pipe is for my BOV and the other I'm holding in my hand........
#4
I'm a boost creep...
Join Date: Jan 2002
Location: Auckland, New Zealand
Posts: 15,608
Likes: 0
Received 8 Likes
on
8 Posts
In the first photo, join the two circled nipples together. Or do your engine a favour and remove the solenoid altogether (cap the IC nipple). You don't need it unless you have a very strict emissions inspection.
The second one is the air supply hose for the BAC valve, but your aluminium pipe between the turbo and rubber elbow has be rotated out of position. The BOV hose should point to the side and the BAC hose should point to the rear.
The second one is the air supply hose for the BAC valve, but your aluminium pipe between the turbo and rubber elbow has be rotated out of position. The BOV hose should point to the side and the BAC hose should point to the rear.
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM
Tem120
3rd Generation Specific (1993-2002)
4
09-07-15 09:53 AM