This is probably a dumb question but does the LIM of a T2 fit on a N/A?

 

Simple answer, NO.

 

Is the bolt pattern different on the motors or what? I dont care if the UIM will bolt up or not just want to know will it bolt to the motor or if the port location is different.

 

4 port motor vs 6 port motor

(see sig)

 

There's enough meat in the TII LIM to mostly grind it out to match ports with a 6 port motor, and IIRC the mounting holes/studs are in the same place, so its not un-doable, its just a bit more difficult than your average bolt-on. Search, there are threads floating around with a lot more detail.

 

The bolt pattern is the same, but the ports are different. The TII lower can be port matched to fit the NA block. However remember that the NA upper will not bolt to it...And if you are intending to turbocharge the engine, there are larger concerns...

 

I was just looking at using the TII Lower and the 3gen upper. not turbocharging. later on I am going to get the TII and put in.

 

Why? The NA intake is tuned to the engine and swapping on the TII intake would result in a power loss.