I'm Thinking U-Joint (What Do You Think?)
#1
Full Member
Thread Starter
Join Date: Dec 2002
Location: Cincinnati
Posts: 130
Likes: 0
Received 0 Likes
on
0 Posts
I'm Thinking U-Joint (What Do You Think?)
I'm hearing a 'CLANK' noise comming from under the center consul thing.
Only happens when I engage the clutch in 1st and in Reverse. Doesn't happen everytime, but does happen often.
Only happens when I engage the clutch in 1st and in Reverse. Doesn't happen everytime, but does happen often.
#3
Senior Member
Join Date: Oct 2001
Location: Grand Rapids, MI
Posts: 596
Likes: 0
Received 0 Likes
on
0 Posts
Sure sounds like it. Jack it up, secure with jack stands and crawl under neath. The front U joint will be a bit difficult to get at but try to move it up and down and sideways. Any give at all and it needs replacement. Do the same for the rear which is easier to get to.
A caution tho, since it does not always "clunk" the hand play may not be very noticable. A "clunk" is a sign of the drive shaft. If you do not know, a blown U joint means you will have to replace the entire drive shaft cuz Mazda choose to design a unit in which a blown U joint could not be replaced. ( been there done that)
However, do a Search on U Joint. Someone in Michigan has a source for replacemnt U joints.
A caution tho, since it does not always "clunk" the hand play may not be very noticable. A "clunk" is a sign of the drive shaft. If you do not know, a blown U joint means you will have to replace the entire drive shaft cuz Mazda choose to design a unit in which a blown U joint could not be replaced. ( been there done that)
However, do a Search on U Joint. Someone in Michigan has a source for replacemnt U joints.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Devon300zx
2nd Generation Specific (1986-1992)
15
09-16-15 06:57 AM