fc3sdude

Alright well i know were the BACV is and, I have checked for vacuum leaks, No vacuum leaks, And i will check on the TB adjustment screws.

fc3sdude

Alright well i know that i have no vacuum leaks, oh and i know were the BACV is.

EnsenCorp

iTrader: (1)

If no vacuum leaks, take an ohm meter and test the BACV, there is a plug towards the bottom of it.....it should read I believe 10.7-12ohm

fc3sdude

Alright well its freezing so i will have to do it here in a little bit...

nunchuckgun

quick question, my rx does the same thing during start only when its cold. when its cold it takes about 3 cranks to start it up, then i have to steady at like 2,000rpm for like 10 minutes or until it reachs that first marker on the temp gauge to get it to stay on. if i just crank it, itll rev up then shut off. when its warmer outside it takes 1 try to start it but i still have to hold it at 2,000 for like 5 min or itll cut off. but after i get it to that first mark on the temp gauge it runs perfectly fine, any ideas? im trying to fix the problem because it really annoys me having to start the car then wait around to get goin

fc3sdude

Well my gauges arent working or i would know my temp to see. Not sure though i have to replace my starter tomorrow so i will just have to see.

fc3sdude

Didn't get around to doin anything today just sat here all day, it was like 20 degrees any ways so im not worried about it.

fc3sdude

Anybody have anything else to contribute.

nunchuckgun

i just tryna get a solution to find out if my junks major or not :\

fc3sdude

I know that my car has good compression once i can get it to like run, it is very strong car..