I started the oil pan gasket project
#1
Senior Member
Thread Starter
Join Date: Aug 2006
Location: Portland, OR
Posts: 433
Likes: 0
Received 0 Likes
on
0 Posts
I started the oil pan gasket project
Ok i've started the remove the oil pan, and there is a motor mount, that is connected to the oil pan, and as i was removing the bolts to the mount i forgot to grab something to keep it in place, sooo now i can't get my bolts back in the designated holes, soooo can i drive my car without the bolts there in the mount or is it not recommended?
#2
NA-BOOSTIN
no you need that mount theres only 2 for the motor. i'm bout to redo my pan also . the best thing to do is use a jack and lift the motor a lil at a time til you can get the bolts back in just dont dent the pan while your raising it
#3
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
All you need to do is just lift the engine up a little and loosly bolt in the aluminium mount to the oil pan. Then let the engine down over the rubber mount and tighten the bolts.
Thread
Thread Starter
Forum
Replies
Last Post