I've been reading through a lot of the project threads on the forum and have found that a few of them contradict each other.
I've read a couple that say you need the TII wiring harness for it to work, and I've read a few that say you can just use the N/A wiring harness but some of the things will be left unplugged.
Can someone shed some light on this ?
I've got a few months before I'm going to do the swap, but I just want to make sure I do my research so I won't forget anything.

 

1. Click on search link located towards the top of page.
2. click on "advanced search" when the small search page pops up.
3. Top left of advance search page enter what you are looking for in the "keywords" box
4. Toggle down to bottom right of advanced search page and scroll down to "2nd generation specific" to narrow the focus of the search or any other forum necessary.
5. Click on the "search now" buton located at the bottom of advanced search page.

 

Haha, I already searched it.
I can't figure out if it is just if you swapping s5 into a s4.

 

40 seconds of searching unearthed this.



https://www.rx7club.com/showthread.p...highlight=swap

 

Well. I'm not for sure what terms you used, but thanks. I searched for a good hour.
No joke.

 

I used s5 swap. Also, I looked at the oldest threads (found on page 9) as opposed to the newest ones. Seems redundant questions such as swap related questions are ignored more today but are responded to more frequently the older the thread is.