How much power can a n/a rear diff hold?
#1
Senior Member
Thread Starter
Join Date: Jun 2006
Location: nebraska, lincoln
Posts: 313
Likes: 0
Received 0 Likes
on
0 Posts
How much power can a n/a rear diff hold?
I am looking at a TII that should be putting down around 300 whp.
I also have a wrecked 90 GTUs that I might part out,
If possible I would like to have the 4.30's
but I doubt the n/a rear end could handle the power.
I don't want to dig in really deep and change the innards of the diffs. or whatever.
I would just like to swap the pumpkins.
From what I have read it prolly won't last.
am I wrong?
I also have a wrecked 90 GTUs that I might part out,
If possible I would like to have the 4.30's
but I doubt the n/a rear end could handle the power.
I don't want to dig in really deep and change the innards of the diffs. or whatever.
I would just like to swap the pumpkins.
From what I have read it prolly won't last.
am I wrong?
#2
Rotary Enthusiast
Join Date: Oct 2002
Location: California, Bay Area
Posts: 1,165
Likes: 0
Received 0 Likes
on
0 Posts
You cant swap the internals, NA is 7 inch T2 is 8 inch. I dont think just swapping pumpkins would be a wise choice either. Sell it and but a T2 4.30 ring and pinion.
#3
Senior Member
Thread Starter
Join Date: Jun 2006
Location: nebraska, lincoln
Posts: 313
Likes: 0
Received 0 Likes
on
0 Posts
that would have to be a infini rear end correct?
or aftermarket?
I thought the only rx7 to come factory w/ 4.30's was the gtus and the infini?
or aftermarket?
I thought the only rx7 to come factory w/ 4.30's was the gtus and the infini?