how do i remove the ignition lock?
#1
Tired of slow pistons!
Thread Starter
Join Date: May 2004
Location: Mooresville/ Durham), NC
Posts: 361
Likes: 0
Received 0 Likes
on
0 Posts
how do i remove the ignition lock?
i just got an 87 GXL a while back. the body is quite strait which is really all i was worried about. i have now figured i might as well not waste a good car too so i've decided to make it into a drag car since i have no title. i also have a smaller problem which is, i have no key. how do i remove the lock. i've already got the back of the switch off so i can turn the car over with the switch and all. i just need to get the lock out so i can steer it. let me know if any of you all know how and put down some info here. thanks! Dave
#2
kill it with BOOMSTICK!
get a copy of the factory repair manual and that should tell you. although about a hundred dollar investment, it is worth its weight in gold if you are doing major modding like you talk about
#4
Senior Member
Join Date: Aug 2003
Location: Alabama just east of B'ham
Posts: 445
Likes: 0
Received 0 Likes
on
0 Posts
There are two screws that hold it in. They do not have a slot for a screw driver. I used a dremel tool with a small cutoff blade and notched them. Used a screwdriver to finish removing it.
Thread
Thread Starter
Forum
Replies
Last Post
risingsunroof82
1st Generation Specific (1979-1985)
8
09-07-15 01:11 PM
SakeBomb Garage
SakeBomb Garage
0
09-04-15 05:20 PM
SakeBomb Garage
Vendor Classifieds
0
09-04-15 05:19 PM