how do I get a little deeper sound from my rx7's exhaust
#1
Rotary Enthusiast
Thread Starter
Join Date: Mar 2001
Location: Caldwell,ID
Posts: 968
Likes: 0
Received 0 Likes
on
0 Posts
how do I get a little deeper sound from my rx7's exhaust
right now my setup is the RB header, into a straight pipe going to a motoria dual catback. I was listening to some clips in another thread about the N1 duals and remember hearing that sound and am wanting something a little more along the lines of that. without changing the actual catback itself is there a premuffler I would be able to put in there to deepen the sound a little bit or is that not going to make a whole lot of difference to the overall tone? if it is going to change the sound which premuffler would be recomended?
Last edited by rxspeed87; 01-02-07 at 11:39 PM. Reason: cause I'm an idiot and still learning how to speel
#3
after i did my exhaust it was high pitched and rather quiet, then i realized the mufflers were really good at quieting things down, i made some new ones and the exhaust note is much lower now and louder, so i would look into your mufflers.
#4
Put a Borla XR-1 muffler in place of the straight pipe. It gets rid of all the raspy, highy pitch sounds of the rotary. We put them on all the RX-7s that go to the shop to have their exhaust done.
#6
Seduced by the DARK SIDE
Join Date: Apr 2001
Location: Orange Park FL (near Jax)
Posts: 7,323
Likes: 0
Received 2 Likes
on
2 Posts
Most any pre-silencer in the cat position will do the job, as long as it will stand up to the heat & sharp vibrating pulses of the RE exhaust.
A turbo also knocks the sharpness out of the exhaust song.
A turbo also knocks the sharpness out of the exhaust song.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post