Has anyone else with a TII had a water leak? I do not believe that mine is caused by the rubber that meets with the IC, but the holes that are visable from the outside through the scoop. How did you deal with it?

Thanks.

 

Mine leaks at the scoop insert also.
I expect they all do.
I just think of it as extra engine cooling.

 

Does yours leak at the actual plastic insert or behind it through the holes in the hood? It's caused rust and I recently found a substantial amount of water sitting in my TID.

 

arnt the t2 hood anuminum, therefore they dont rust they corrodie.. i have one and mine has a little leak to it too

 

The rust occured in the engine bay on the frame rails from water leaking through the Al hood.

 

o, sorry i missunderstood what your were saying

 

Surely I'm not the only one in the history of this vehicle who's had a leak as I've described it?

 

Just another reason to pull the TII hood and go with a good FMIC and an aluminium N/A hood. I think that would look ****.

 

hhhmmm mine leaks but not that much. In fact i've never heard of one leaking so bad as to cause corrosion? Maybe some RTV or Hilomar?

 

Here are pictures of two spots that I suspect. In the first one notice how in the left side of the circle is light colored? I could actually stick my finger through the scoop and around the back of the plastic part and you could see it in that picture! In the second one, notice the area I highlighted? That is a hole that goes right through the hood! I could stick my finger through that hole and you'd be able to see it.