i just picked up a HKS TMIC,it looks a little confusing.i was wondering if anyone had prior experience installing this or any ppics will be useful.Thanks

 

Well... It should be pretty straight forward. It should only be able to go on one way.

 

It should bolt right in, unless you didn't get the TB elbow that comes with it, in which case, good luck.

 

i dont think i got it.is it aluminum or a rubber elbow?i got a couple of couplers with it but thats it.the intercooler outlet that goes to the TB looks a little short.

 

It comes with a special throttle body inlet that replaces the stock one. It is larger and has a different angle than the stock one to match the hks tmic outlet. Do you have a s4 or s5 car?

 

i own a s5,i did a s5 turbo swap on my vert.

 

PVC and silicon couplers go a long way...

 

i have one
http://i6.photobucket.com/albums/y20...C/DSC03238.jpg
came with my car, but i believe the throttle body elbow is specific for it.

 

not to thread jack but how well do these perform? been pretty interested but not sure how much boost they will hold up to... looking to get 325 hp out of car max 350

 

hypertek,you got any more pics? did it have a charge pipe when you first got your car?i have a charge pipe that came with it,it has hks on it,nice setup btw

 

Your missing the elbow piece , it looks like the stock but 90 degree up sort of squished.

I would recommend taking off the stock one, lay the HKS intercooler ontop and see how much of an angle you need. Then make a hole and make a piping out of emptly toilet rolls till you get it ot match the HKS unit.

then bring it to a tigwelder.

 

well this is up for sale,since ive lost interest.Thanks