Hesitation when turning left!?
#1
- Make Haste -
Thread Starter
Join Date: Apr 2005
Location: Calgary, Alberta
Posts: 1,648
Likes: 0
Received 0 Likes
on
0 Posts
Hesitation when turning left!?
Like the thread name says, i get hesitation when i take a left hand corner a little quicker then normal, even if i'm 1/4 on the throttle and off boost....
right turns seam fine but left turns i get the hesitation....
this is kinda retarded, what could be causing this!?
right turns seam fine but left turns i get the hesitation....
this is kinda retarded, what could be causing this!?
#3
Seduced by the DARK SIDE
Join Date: Apr 2001
Location: Orange Park FL (near Jax)
Posts: 7,323
Likes: 0
Received 2 Likes
on
2 Posts
Here is my little write up.
link to pictures
Of course a new strainer is best, but I am a cheapskate.
link to pictures
Of course a new strainer is best, but I am a cheapskate.
#4
- Make Haste -
Thread Starter
Join Date: Apr 2005
Location: Calgary, Alberta
Posts: 1,648
Likes: 0
Received 0 Likes
on
0 Posts
pickup filter on fuel pump is dirty!?
this was changed when i installed my walbro 6months ago....
this was changed when i installed my walbro 6months ago....
Last edited by Archangels; 05-01-06 at 10:13 AM.
#5
- Make Haste -
Thread Starter
Join Date: Apr 2005
Location: Calgary, Alberta
Posts: 1,648
Likes: 0
Received 0 Likes
on
0 Posts
aaaaaahhhhhhhh ****, i was just thinking....
could the fuel pump strainer cause other types of hesitation aswell, and not only the turning left?...
could the fuel pump strainer cause other types of hesitation aswell, and not only the turning left?...
#7
- Make Haste -
Thread Starter
Join Date: Apr 2005
Location: Calgary, Alberta
Posts: 1,648
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by buttsjim
This would be a fluke, but I had a "hesitation" (actually cut-out) on left hand turns because the plug wasn't tight on the airflow meter.
sooooooooo, after i puttered around for a block it went away....
mabe i should check my vac. lines again, because to have a strainer foul in 3000km's is odd to me....
Trending Topics
#8
Former Moderator. RIP Icemark.
Please read the FAQ for FC sticky thread before posting. IT covers many of the commonly asked questions such as the one this thread was started with.
Thread closed. Covered in the FAQ for FC sticky thread found at the top of this, the 2nd gen RX-7 technical section.
Thread closed. Covered in the FAQ for FC sticky thread found at the top of this, the 2nd gen RX-7 technical section.
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 11:02 PM
rx8volks
Canadian Forum
0
09-01-15 10:46 PM