Help on timing..can't find the answer.
Thread Starter
Full Member
Joined: Jul 2004
Posts: 164
Likes: 0
From: Sacramento
Help on timing..can't find the answer.
Every where I read about timing, it requires you to line up the yellow mark of the crank with the front housing yada yada yada...well here's my problem...I HAVE NO MARKS!
I need to install the CAS on my rebuild and have nothing to go by. How can I get everything TDC?
I want to get everything marked properly as well when it's in...but how?
I need to install the CAS on my rebuild and have nothing to go by. How can I get everything TDC?
I want to get everything marked properly as well when it's in...but how?
This link might help you. I found this on one of my search campaigns when I was resetting timing. I have not seen an engine that had the marks missing, faint in a lot of cases, but not missing. You might need to clean the dirt/grime off of the pulley.
http://members.optusnet.com.au/~onec...-%20part%20one
http://members.optusnet.com.au/~onec...-%20part%20one
Thread Starter
Full Member
Joined: Jul 2004
Posts: 164
Likes: 0
From: Sacramento
Originally Posted by AcidShock
This link might help you. I found this on one of my search campaigns when I was resetting timing. I have not seen an engine that had the marks missing, faint in a lot of cases, but not missing. You might need to clean the dirt/grime off of the pulley.
http://members.optusnet.com.au/~onec...-%20part%20one
http://members.optusnet.com.au/~onec...-%20part%20one
I just need to get marks on the pulley now. THANKS AGAIN.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM