2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

help please

Thread Tools
 
Search this Thread
 
Old Jan 22, 2007 | 01:48 PM
  #26  
J-Rat's Avatar
Alcohol Fueled!
Tenured Member 20 Years
iTrader: (2)
 
Joined: Jan 2002
Posts: 11,093
Likes: 2
From: Hood River oregon
Originally Posted by rx7turbojunkie
this is the other one, it is on the back side of the motor towards the firewall just under the intercooler, it was hanging by the transmission.
That one gets attached to the firewall. There is a tab for it to slide on to.
Reply
Old Jan 22, 2007 | 01:52 PM
  #27  
RotaryEvolution's Avatar
Sharp Claws
Tenured Member 15 Years
iTrader: (30)
 
Joined: Oct 2003
Posts: 5,107
Likes: 50
From: Central Florida
right inboard of the wiper motor.
Reply
Old Jan 22, 2007 | 04:12 PM
  #28  
rx7turbojunkie's Avatar
Thread Starter
Junior Member
 
Joined: Jan 2007
Posts: 16
Likes: 0
From: indiana
thanks guys, now it will idle at 1400 rpm, however at a hard blow of the gas pedal it tries to die, if i slowly ease the gas pedal it will rev, but at 3800-4000 it pops very loud and misses badly, any ideas, also neither of my throttle adjustments will idel my car any lower. this is very frustrating.
Reply
Old Jan 22, 2007 | 04:19 PM
  #29  
rx7turbojunkie's Avatar
Thread Starter
Junior Member
 
Joined: Jan 2007
Posts: 16
Likes: 0
From: indiana
okay, so i payed $300.00 for this 87 turbo 2 because the owner thought the apex seal was gone, you think i should sell it now for what i have in it aprox $450.00
Reply
Old Jan 22, 2007 | 04:36 PM
  #30  
rx7turbojunkie's Avatar
Thread Starter
Junior Member
 
Joined: Jan 2007
Posts: 16
Likes: 0
From: indiana
it has 89703 orig. miles on it.
Reply
Old Jan 22, 2007 | 04:40 PM
  #31  
mort2002's Avatar
Rotary Enthusiast
Tenured Member 10 Years
iTrader: (1)
 
Joined: Jul 2003
Posts: 1,248
Likes: 0
From: Prosser Washington
wish you were closer to me id buy it up....
Reply
Old Jan 24, 2007 | 08:11 AM
  #32  
rx7turbojunkie's Avatar
Thread Starter
Junior Member
 
Joined: Jan 2007
Posts: 16
Likes: 0
From: indiana
can anyone please post a picture of the wiring harness for the pressure sensor, i think the wires are crossed, i need to see what wire goes where in that harness, at the connector for the pressure sensor
Reply




All times are GMT -5. The time now is 03:04 PM.