Help!! code 27 and mop/omp problems
10-23-04, 03:13 PM
#1
Junior Member
Thread Starter
Join Date: May 2004
Location: Phoenix AZ
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
Help!! code 27 and mop/omp problems
I Have trouble shot this as far as I can--I can drive the car for 10-15 minutes and then I get a check engine light and soon after the car will go into Limp-fail safe mode. If I shut the car off then I can start the car right back up and drive it for another 10-15 min till it goes back into limp mode. I get a code 27-omp. I get the right resistance at the connector going to the Omp and I get Continuity going to the ecu. With the Key to On I get 12v at B1 and B2.
Any help would be appreciated-- If I get power at B1 and B2 the ecu should be fine?
Any help would be appreciated-- If I get power at B1 and B2 the ecu should be fine?
10-23-04, 04:24 PM
#2
Junior Member
Thread Starter
Join Date: May 2004
Location: Phoenix AZ
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
I also have 12v coming out of the ecu on all four pins--the more I read in the archives leads me to the mop---The dealer is Tooooooooo$$$$$$$$$$ does anyone have one to sell/trade-give
It is a S5 so premixing is kinda out of the Question. I might also be looking for a n351 Ecu if someone has on laying around
It is a S5 so premixing is kinda out of the Question. I might also be looking for a n351 Ecu if someone has on laying around
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM