Header help
#1
Senior Member
Thread Starter
Header help
1986 NA S4
what header combo is the right one from Racing Beat?
Do I need an actuator port on BOTH the header and presilencer or only on one?
I see one header with a double collector and one further down with a single collector. The double has the port, the single doesn't.
The plan is to run a single setup from either HKS or Apexi.
Anyone know which parts I will need from the engine to the "catback" listed above?
Thanks!
what header combo is the right one from Racing Beat?
Do I need an actuator port on BOTH the header and presilencer or only on one?
I see one header with a double collector and one further down with a single collector. The double has the port, the single doesn't.
The plan is to run a single setup from either HKS or Apexi.
Anyone know which parts I will need from the engine to the "catback" listed above?
Thanks!
#2
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,930
Received 2,666 Likes
on
1,889 Posts
you do only need the one 6 port pickup tube. if you want to bolt up to a stock, or off the shelf cat back then you need the single exit header, 16130 or 16131
and then the pre-silencer that lets you use the stock split air pipe, https://www.racingbeat.com/RX7-1986-...ers/16405.html
and then the pre-silencer that lets you use the stock split air pipe, https://www.racingbeat.com/RX7-1986-...ers/16405.html
The following users liked this post:
Spider2k (05-17-21)
Thread
Thread Starter
Forum
Replies
Last Post