2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Which grommets and o rings do I need to replace on the injectors?

Thread Tools
 
Search this Thread
 
Old Jul 10, 2006 | 03:41 PM
  #1  
Mindspin311's Avatar
Thread Starter
Powered By Trochoids
Tenured Member 05 Years
 
Joined: Oct 2004
Posts: 1,457
Likes: 0
From: Philly | PA
Which grommets and o rings do I need to replace on the injectors?

I have fuel leak and I believe its due to a bad o ring or grommet on one of my injectors. I havent pin pointed which one, but I figure I might as well replace them all while I have the car apart. Can someone tell me which ones I would need to replace and maybe even the part number? Thanks.
Reply
Old Jul 10, 2006 | 03:48 PM
  #2  
My5ABaby's Avatar
Rotaries confuse me
Tenured Member 10 Years
iTrader: (7)
 
Joined: May 2006
Posts: 4,219
Likes: 3
From: Murfreesboro, TN
Upper Grommet
Lower Grommet
Top O-Ring

You might also need new pintle caps.

http://www.mazdatrix.com/c-6.htm
Reply
Old Jul 10, 2006 | 05:29 PM
  #3  
Mindspin311's Avatar
Thread Starter
Powered By Trochoids
Tenured Member 05 Years
 
Joined: Oct 2004
Posts: 1,457
Likes: 0
From: Philly | PA
Just pulled out my primaries, one of top grommets was dried out and very brittle and eventually broke as i was taking it off, must have been the culprit
Reply
Old Jul 10, 2006 | 05:33 PM
  #4  
88rxn/a's Avatar
tom port.. AKA streetport
Tenured Member 15 Years
iTrader: (6)
 
Joined: Jan 2005
Posts: 4,658
Likes: 0
From: ludlow, pa
good time to have them cleaned.. unless they have been recently...
Reply
Old Jul 10, 2006 | 05:35 PM
  #5  
zero-13's Avatar
Shut yo mouth!!
Tenured Member 05 Years
 
Joined: Jun 2004
Posts: 73
Likes: 0
From: Whale's Vagina, CA
If you get your injectors cleaned by Witchhunter.com, I think they give you new o-rings and spacers. You might as well get them cleaned if you can spare not having your car for a couple of days. Just a thought. -Jeromy
Reply
Old Jul 10, 2006 | 05:38 PM
  #6  
Rotary_Knight's Avatar
Senior Member
Tenured Member: 20 Years
iTrader: (4)
 
Joined: Jun 2004
Posts: 727
Likes: 2
From: California
I just picked my o-rings up from Mazda today. Part # 8574-13-253 I believe they are about $3.50 a piece. Kinda pricey for a lil piece of rubber but oh well.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
FD7KiD
3rd Generation Specific (1993-2002)
15
Feb 26, 2021 10:12 PM
FD7KiD
Single Turbo RX-7's
1
Aug 17, 2015 11:50 PM
Leeroy_25
3rd Generation Specific (1993-2002)
4
Aug 17, 2015 12:53 PM




All times are GMT -5. The time now is 04:34 AM.