got it running
got it running
after i replaced the o rings on the injectors i started it up and it would go to 3000 and then die.
after I fixed that and finally got it to start it idled really low and is sluggish when hitting the gas.
I then shut it off after a couple of min's and checked everything. when I tried to start it again it didn't want to start.
what is it this time??
after I fixed that and finally got it to start it idled really low and is sluggish when hitting the gas.
I then shut it off after a couple of min's and checked everything. when I tried to start it again it didn't want to start.
what is it this time??
do you think the battery will make the acceleration lag though?
it did get low from trying to start it but then I let it run for awhile after I got it started.
the throttle response is really slow.
everything was ok and it ran great before I replaced the injector o-rings.
it did get low from trying to start it but then I let it run for awhile after I got it started.
the throttle response is really slow.
everything was ok and it ran great before I replaced the injector o-rings.
Senior Member
Joined: Jan 2004
Posts: 659
Likes: 0
From: Delaware
Yea I think u should try charging the battery up. About it lagging...i really dunno. Are the injectors themselves working good (are they new or cleaned or did u just replace the o-rings)? Good luck and these problems can be a bitch to diagnose!
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
turbo-minivan
General Rotary Tech Support
69
Feb 4, 2016 12:29 AM
The Shaolin
2nd Generation Specific (1986-1992)
9
Sep 14, 2015 07:50 PM



