got a couple questions:wire and pressure sensor
#1
my fc broke
Thread Starter
Join Date: Feb 2003
Location: rohnert park,CA/ bay area
Posts: 2,231
Likes: 0
Received 0 Likes
on
0 Posts
got a couple questions:wire and pressure sensor
im not sure where this wire goes that i have coming off the engine harness on my 87TII, the wire is yellow right a red strip and comes off over by the oil filer neck. it doesnt have a connector on it cuz it broke off buti dont know where it goes. also what color wire goes to the thermo neck for the gauge. last bu not least i think i might have a NA pressure sensor, because my friend pointed it out and when i try to boost the car just stumbles and starts spitting but it ill cruise finebut whont hold idle.
-Neil
-Neil
#3
Alcohol Fueled!
iTrader: (2)
Originally Posted by 1SxyRXy
im not sure where this wire goes that i have coming off the engine harness on my 87TII, the wire is yellow right a red strip and comes off over by the oil filer neck. it doesnt have a connector on it cuz it broke off buti dont know where it goes. also what color wire goes to the thermo neck for the gauge. last bu not least i think i might have a NA pressure sensor, because my friend pointed it out and when i try to boost the car just stumbles and starts spitting but it ill cruise finebut whont hold idle.
-Neil
-Neil
the yellow wire is probably either the oil press sender or the temp sender. I would have to consult the FSM for the wire color. You missing any of those readings?
#4
my fc broke
Thread Starter
Join Date: Feb 2003
Location: rohnert park,CA/ bay area
Posts: 2,231
Likes: 0
Received 0 Likes
on
0 Posts
i have the oil pressure gauge hooked up, and i thought the water temp gauge read from the thermo neck on S4's, there is one sensor that doesnt have a wire on the rear iron but im not sure if whats its for
Thread
Thread Starter
Forum
Replies
Last Post
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM