GB FMIC complete kits interest
#1
Senior Member
Thread Starter
Join Date: Jan 2002
Location: nunya
Posts: 446
Likes: 0
Received 0 Likes
on
0 Posts
GB FMIC complete kits interest
Check this out and let me know ya'll... hope to have exact $'s and specs by end of month.
http://www.teamfc3s.org/forum/showt...&threadid=44157
http://www.teamfc3s.org/forum/showt...&threadid=44157
#2
#4
I would be interested in a complete kit and when you say BOV will we have a BOV attached to the piping and what kind etc. Also when you get yours done pics will help 10 fold
#7
Senior Member
Thread Starter
Join Date: Jan 2002
Location: nunya
Posts: 446
Likes: 0
Received 0 Likes
on
0 Posts
sorry link didn't work. Yeah if you want just a piping kit I'm sure I can make that happen. Far as BOV's go I'm comparing a group buy on real Greaddy RS vs the knockoffs on Ebay. I will be taking my car in to get the piping next week. It will be similar to the greddy routing but with none to minimal hacking of the brake ducts and bumper. I'm aiming for a very clean fabrication. After I get my piping in, I'll have a better idea of piping kit costs. To which would include piping, couplers, standard clamps, and BOV. I'm also looking to move my air filter to under the passenger headlight, so I'll look into throwing the piping for that into the deal. Just bought a pneumatic saw from Harbor Freight to do the hacking $20.
Trending Topics
#14
Senior Member
Thread Starter
Join Date: Jan 2002
Location: nunya
Posts: 446
Likes: 0
Received 0 Likes
on
0 Posts
Well I've tried to get authtority before to sell powdercoating services with no reply, I even offered to donate money to the forum based on revenues generated from this forum. And finally I did get some biz and I tried to kick $10 to the forum, but again no reply so whattya want me to do?? As well this is only a link to TeamFC, tough to maintain to threads. There have been some updates to that thread, basically I found most interest in just piping kits so thats the route its gone and I'll have prices in the next week or two. I snapped tons of pics of my build up so we'll have a FMIC how-to install thread there too.
#15
MP T-70 = Fun
Join Date: Dec 2004
Location: Charlotte and WCU
Posts: 1,049
Likes: 0
Received 0 Likes
on
0 Posts
https://www.rx7club.com/showthread.p...highlight=fmic the whole fmic setup was under $450.
you can see i used a N/A TB elbow... This setup is cheap... there is not alot of bends. You will have to cut a little... the pipes are pretty cheap on ebay. I used a $15 sawzall from harbor freight to cut the stuff.
you can see i used a N/A TB elbow... This setup is cheap... there is not alot of bends. You will have to cut a little... the pipes are pretty cheap on ebay. I used a $15 sawzall from harbor freight to cut the stuff.
#16
Senior Member
Thread Starter
Join Date: Jan 2002
Location: nunya
Posts: 446
Likes: 0
Received 0 Likes
on
0 Posts
yeah cept I'm keepin my AC/PS, I have a small battery but it sets towards the leading coil to keep away from the radiator. So theoretically this kit would fit a high % of FC's. Darn BOV's are silly $$. Where'd ya get your headlights, I've seen a few FC's with em and it looks really good man.
Thread
Thread Starter
Forum
Replies
Last Post