ok i have gf210 lowering springs matched with the apexi t mac shocks and struts now on my t2...i like how they sit but do not love it yet...i dont wanna go down the coil over route but wanna drop the front 3/4 of an inch mor than what it already is...i went to racingbeat.com and saw the"front suspension lowering kit" but no way im paying $204 plus shipping for it...anyway has anyone do some custom work to acheive simular results...i wanna do it the right way also...any tips would be much appreciated. thanks

 

ok not sure what your asking here, but the Tanabes drop your car 1.5" dont you think thats low enough? MY car is only 3.5 " off the ground with these Tanabes and I run my AGX's stiff. If I didnt do that I would be hitting bottom constantly.
I wouldnt drop it anymore if your smart.

Chris

 

Same setup and I have to watch everywhere I go to keep from knocking the front lip or exhaust off.

 

if you really care about the look as opposed to the performance, why didn't you get the tanabe's that are meant for dropping? I think it was called Drop Feeling or something like that.

 

yea i have the rb turbo back exhaust and the cross brace on the y pipe scrapes going in my garage slightly...i need just a front lip ...looks like the front a lil higher than rear but i know its not measured...sorry

 

i want my back to be little more lower and the front its fine, i lowed with tein spring, well i need coilovers make the ride height perfect.