Fresh ported rebuild. Plz help.
#1
Junior Member
Thread Starter
Fresh ported rebuild. Plz help.
Hey guys!! Just recently got my first Dorito, had the engine fully rebuilt and added large street port while I was at it by pineapple racing. So I'm curious, Will i hurt my new engine by not having anything else done to support the large street port? I figure it has to mess with my air/fuel ratio, Right? Do I need to run a stand alone ECU? Should I upgrade my cooling system too? (I currently am getting the coolant buzzer from hell too).
essentially I want to know what I should do to it next? This is all new territory to me, I'm learning. (Trying to at least) I appreciate any info y'all have to spare!! Thank you guys!! Much love my fellow rotards!!
essentially I want to know what I should do to it next? This is all new territory to me, I'm learning. (Trying to at least) I appreciate any info y'all have to spare!! Thank you guys!! Much love my fellow rotards!!
#2
Junior Member
If you find an issue, stop driving the car fix the issue first. With the coolant buzzer, you are going to want to make sure your system is in order. You DO NOT want to overheat your freshly rebuilt motor!! If you can't figure out the issue have a shop check it out. There's a way to just take care of cause of the buzzer but just check your coling system because the buzzer goes off because of either overheating or low coolant. It shouldn't be going off.
Thread
Thread Starter
Forum
Replies
Last Post
boostup
2nd Generation Specific (1986-1992)
2
11-25-07 10:39 PM
ballin!matt
3rd Generation Specific (1993-2002)
13
02-23-07 04:43 AM
93red
3rd Generation Specific (1993-2002)
4
04-09-06 12:26 PM