I've noticed that HAILERS is the local wiring guru, so, Ifigured he'd be the best to answer my question. I just did a Jspec TII swap into my S4 N/A. I went to rewire the Walbro that I bought, but the little "heat sink" looking thing was not in my N/A. No problem, right? I'll just pull it off of the TII. But, where do the wires plug into my N/A? I, unfortunately, didn't swap out the chassis harness. So, I'm using the N/A chassis harness with the TII main harness. It seemed to run fine (not under load, still waiting for the rear end) so, I dunno. Please help me, it's so close to being done. Oh, also, the alt. power wires(2 prong clip) are nowhere to be found. How/where could I hardwire those? Thanks.

 

On the alternator, connect those female blade connectors, the ones like you hook to the back of a raw speaker... Put one on each wire. to connect them
Start the motor, touch the wires to the blades on the alternator, if there is a little spark reverse them and your done. It sound scary, but it works and doens't hurt.

 

title edited... no names in titles... PM a person if you need a specific persons help

 

^^bump

 

^^ nothing? Someone? Hello? I really need to know this.