3rd gen UIM on s4 LIM
#1
not sure anymore
Thread Starter
Join Date: Aug 2003
Location: leawood,kansas
Posts: 1,182
Likes: 0
Received 0 Likes
on
0 Posts
3rd gen UIM on s4 LIM
I know this has been talked about before but I can’t seem to find anything using the search. Anyway I know this has been done but how hard is it, and do i also use a 3rd gen throttle body or can i use mine of my s4 one. Any info would be nice.
Thanks
I have a 88t2
Thanks
I have a 88t2
#3
Moderator
iTrader: (7)
- FD UIM to S4 LIM much harder to retrofit (bigger difference in offsets of bolts and ports)
if any reason to upgrade to FD UIM is use FD TB as well (slightly bigger), no point of going thru hassle using FD UIM and then downgrade to smaller TB which does not fit and will require again lot of machining...
if any reason to upgrade to FD UIM is use FD TB as well (slightly bigger), no point of going thru hassle using FD UIM and then downgrade to smaller TB which does not fit and will require again lot of machining...
#5
Moderator
iTrader: (7)
much easier, been covered, use search
i have it to S5 LIM, but i still use spacer to make transition as smooth as possible
http://rx7cz.net/photos/workshop85/IMG_3295.JPG
i have it to S5 LIM, but i still use spacer to make transition as smooth as possible
http://rx7cz.net/photos/workshop85/IMG_3295.JPG
#6
not sure anymore
Thread Starter
Join Date: Aug 2003
Location: leawood,kansas
Posts: 1,182
Likes: 0
Received 0 Likes
on
0 Posts
tell me more on how you did it pleez. I like how it looks. I think i remember your thread you had some pics of the spacer???
How well does the s5 LIM bolt up to the s4 block, and s5 LIM to 3rd gen UIM. did you also put a spacer from the LIM to the block?
How well does the s5 LIM bolt up to the s4 block, and s5 LIM to 3rd gen UIM. did you also put a spacer from the LIM to the block?