Fitting a Boost Gauge
08-07-01, 09:31 PM
#1
Full Member
Thread Starter
Join Date: Mar 2001
Location: Adelaide, SA, Australia
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
Fitting a Boost Gauge
What is the best way to fit a mechanical boost gauge in a T2?
Any hints/tips/experienceswould be much appreciated.
thanks
Daniel
Any hints/tips/experienceswould be much appreciated.
thanks
Daniel
08-09-01, 07:45 AM
#2
Lives on the Forum
Cut the vacuum line going into the stock boost sensor on the passenger side strut tower.
Insert a "T" to tap into the vacuum line.  Run the T'd line back along the firewall across to where the main harness goes into the firewall.  Run the vacuum line through that grommet.
Now you've got the vacuum line into the interior of the car.  Wire up the other wires via instructions.  Mount where YOU think it would look pretty.
-Ted
Insert a "T" to tap into the vacuum line.  Run the T'd line back along the firewall across to where the main harness goes into the firewall.  Run the vacuum line through that grommet.
Now you've got the vacuum line into the interior of the car.  Wire up the other wires via instructions.  Mount where YOU think it would look pretty.
-Ted
Thread
Thread Starter
Forum
Replies
Last Post