filter seal
#1
pistons=teh suck
Thread Starter
Join Date: May 2003
Location: NJ
Posts: 933
Likes: 0
Received 0 Likes
on
0 Posts
filter seal
i just put in my new k&n panel filter. the bolts that are supposed to hold the air box on are all sorts of fucked up. only 3 of the 8 actually screw in and hold it tight. 2 of them dont do much because the thread that was supposed to be built into the plastic so i can screw in is pulled out. the other ones just sit there. pretty much the whole top half of it isnt really together like it should be. its not like gaping open, but is it safe to run the car with it like this? i did use the k&n sealer oil if that helps any. does anyone have any left over parts they could send me because i know a lot of you took it off for a cone filter. thanks.
#3
Seduced by the DARK SIDE
Join Date: Apr 2001
Location: Orange Park FL (near Jax)
Posts: 7,323
Likes: 0
Received 2 Likes
on
2 Posts
Check with the parts mongers like:
www.rotaryresurrection.com
www.rotaryresurrection.com
#4
Gas Guzzlin' Tire Junkie
Join Date: Aug 2002
Location: 19805
Posts: 459
Likes: 0
Received 0 Likes
on
0 Posts
take the loose screws out and use zip ties. i did that w/ no problems until i upgraded to a K&N cone. also i left the metal liner in each hole. it seemed to hold better.
Last edited by jetfire76; 07-16-03 at 11:50 AM.
#5
I R SAD PANDA W/O BAW
I only have 2 screws holding in my stock air box as of now. Both on the left side. The plastic piece that goes from the snorkel holds it in place for me. By the way I only had 2 screws to begin with but will be doing away with the stock air box.
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
SakeBomb Garage
0
09-04-15 05:20 PM