Rob!,that is just "terrible"..(lol,just kidding,I want your talent!)

I just ordered the RPM stuff too.I've been waiting on this part to get into production. Under this assumption I collected all the other parts.
This is gonna get done ..again.(been there once,had ECU problems,so I switched back to stock,hunting gremlins).

 

dont forget the throttle body

 

What did you use to paint that? Looks absolutely fantastic.

 

its a black chrome process, but the trick is really getting the cast parts smooth enough. I also ground off some brackets.

 

And the elbow. Hopefully I can find it all together, vs. having to piece everything out separately. Do you know if the FD BAC valve is PWM, or is it a stepper motor?

 

dont know to be honest, I run a standalone so it doesnt matter to me
the main reason the FD upper appealed to me was hiding the BAC valve. I had a remote set up mounted on the firewall and the valve stuck so I have had it disconnected ever since

dont know if you were following but I changed the angle of the elbow, I didnt like where it routed the pipe

 

This appeals to me for the full range TPS

And the BAC being pwm or stepper does matter. I have a standalone too, and it will require different settings to operate if it's a different type. On my standalone, I will have to build a different circuit on the board if it's not a PWM controlled valve (Megasquirt's all about DIY)

 

Hi all I have just done a post CLUB13b with a write up of the REACTION RACING Adaptor.

check it out: CLUB13b 13BT Build: UIM Conversion | CLUB13b: World Wide Rotary Alliance

KANAGAWA REPRESENT!