2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Engine and Transmission mounts

Thread Tools
 
Search this Thread
 
Old Feb 9, 2008 | 06:33 PM
  #1  
RotarySupra's Avatar
Thread Starter
ZOOM-ZOOM Forever!
Tenured Member 15 Years
iTrader: (-1)
 
Joined: Jun 2005
Posts: 512
Likes: 0
From: SoCal/Arizona
AZ Engine and Transmission mounts

I want to replace the engine mounts and my transmission mounts on my 90 GTUs, how many engine mounts are there to replace? how many transmission mounts do i have to replace? Any help is appreciated and Thanks.
Reply
Old Feb 9, 2008 | 07:59 PM
  #2  
Fc3s_d1jp's Avatar
Senior Member
Tenured Member 05 Years
 
Joined: Nov 2005
Posts: 268
Likes: 0
From: Austin,TX
2 engine 2 trans.
Reply
Old Feb 9, 2008 | 08:09 PM
  #3  
RotarySupra's Avatar
Thread Starter
ZOOM-ZOOM Forever!
Tenured Member 15 Years
iTrader: (-1)
 
Joined: Jun 2005
Posts: 512
Likes: 0
From: SoCal/Arizona
so i can buy them in pairs right? are they difficult to install?
Reply
Old Mar 4, 2008 | 10:09 PM
  #4  
ctsupacat's Avatar
Junior Member
Tenured Member 15 Years
 
Joined: Mar 2008
Posts: 13
Likes: 0
From: Philadelphia
looks like the engine mounts are a major undertaking because its difficult to jack the engine up unless you have an engine jack (overhead jack) . The cheapest I found for engine mounts was at racing beat.com

tranny mounts don't look that hard, but getting the rusty bolts off is always a chore. It's nice to have a torch to loosen the bolts. Don't burn any wires and jack up the tranny just enough to get the tension off the mounts. don't jack up too high or you might break your rear-axle.
I think i'm just gonna get a mechanic to do mine.
BTW if you are gonna replace your engine mounts, you might as well change your oil pan gasket.
Reply
Old Mar 5, 2008 | 12:53 AM
  #5  
Black91n/a's Avatar
Lives on the Forum
Tenured Member 10 Years
 
Joined: Sep 2003
Posts: 5,707
Likes: 6
From: BC, Canada
You can jack up the engine enough to change the mounts by jacking under the bellhousing, I've done it before.
Reply
Old Mar 5, 2008 | 02:57 AM
  #6  
certifiednut's Avatar
Mike Honcho
Tenured Member 05 Years
 
Joined: May 2007
Posts: 321
Likes: 0
From: des moines iowa
banzai-racing.com you can buy motor and trans seperate or as a set, all polyurethane
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
BNR34RB26DETT
Build Threads
42
Feb 28, 2018 11:27 AM
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM




All times are GMT -5. The time now is 06:22 PM.