shpaintball

i replaced my UIM and LIM with new ones i did emissions removal all but the egr valve ....removed rats nest and now the car wont idle and i dont have fuel pressure ....i have 3 vac lines one from the LIM to the dynamic chamber and one from the FPR to the back of the dynamic chamber by the bacv valve what could cause my car to not idle and hold no fuel pressure relative to removing the emissions and rats nest***

i kno it could be a vac line but they are all capped ....i removed the omp and replaced it with bolts on the LIM but not the block they are capped tho....no air pump or acv thing that connects to it .....ANY HELP WOULD BE GREATLY APPRECIATED thanks : )

turboIIrotary

iTrader: (9)

is your fuel pump working?

TehMonkay

iTrader: (-1)

fuel lines backwards?

shpaintball

no and no.....fuel lines work ....fuel pump checked out i looked into that very first ....anyone else have an idea?

DarkKnightFC

Could be the filter...

DarkKnightFC

The oil injectors need to be removed and bolts in thier place not just capped off. Otherwise that is almost a direct hole into the block if I'm not mistaken.

Chris

shpaintball

havent checked the filter? ....and your right about the omp's i capped the ones on the block but didnt remove them ...but the ones on the manifold i put bolts in ....anything else i should check? like y fuel pressure would drop? i can drive the car but no idel ....bad o2 sensor? ...

prjct87rx7

iTrader: (7)

if you replaced the manifold you must have had to swap the tps???? adjust it...

shpaintball

i never thought of that ....good call any thing else ?