ecu harness question
04-16-02, 09:35 PM
#1
Junior Member
Thread Starter
Join Date: Apr 2002
Location: virgina
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
ecu harness question
does any rx7 87 turbo owner know witch plug the bac valve's conector plugs into the ecu. I am trying to find out if there is a short in the wire and i dont know where the other end is any help would be much appreciated
04-16-02, 10:17 PM
#3
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
Pin 2Q. EDIT: Its the middle plug. The plugs are labled from right to left looking into the back of the plug with it connected. 2A is far ight on the top row. 2B is just below, 2C is...............and on and on it goes until you get to 2Q.
Last edited by HAILERS; 04-16-02 at 10:21 PM.
04-17-02, 07:16 AM
#5
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
86rx7gxl........see this thread https://www.rx7club.com/forum/attach...&postid=488879 and the jpg that I attached for the ecu. Also go to http://iluvmyrx7.com and download the wiring diagrams from the 88 model factory manual. Oops, make that https://www.rx7club.com/forum/showth...threadid=59266 or https://www.rx7club.com/forum/attach...&postid=488871 or https://www.rx7club.com/forum/attach...&postid=488875
Last edited by HAILERS; 04-17-02 at 07:23 AM.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM