this is odd my door light stays on.. even when the doors are closed.
the 7.5 amp fuse is blown. i put 2 in and it still doesn't work... both are blown. now im beging to think that its something else.. what could it be? the interior light that comes on inside doesn't come on and same with the push button light... any ideas ? and the beeping sound that it supposed to make when you have key in the ign... thats gone but its faded out i can bearly hear it.

 

Make sure you door contact switches are working. Also, if you are putting fuses in and they are blowing then you have a short somewhere on that circuit. You are going to have to trace the wiring down and looks for chaffed wires, etc.

 

what else could i check? when i solder i just resolder the single points right? i haven't much electrical exp. i've just solder about 2 wires together but when it could to comp board i just resolder the same point right ? don't connect them right with a single soldering wire? IM a noobie i have to admit that to electical probs on the fc

 

Blowing fuses is not related to something needing re-soldering unless you re-soldered it first and now it blows fuses.

So step away from the soldering iron.

You probably have a pinched wire. What other work did you do recently? Add any equipment??? Change anything? drop down the mirror assembly?

 

i was checkin the mirrior assembly in how it works and holds together. then thats when the door light popped up. you suspect that its in there ?

 

iono but i did resolder some of the solding joints in the clock and logicon and they work better but the the idiot light still doesn't show the time

 

needs the room fuse for the clock to work.

 

ill check the wring in the mirrior and see if anything is wrong.