dangeling wire
#26
Former Moderator. RIP Icemark.
Originally Posted by Mombodogs
OK, I will describe what I found that the female end-"dangling wire" goes to. Its a square sensor-relay, with a "washer" attached for mounting to the ending as I assume, ground, with the numbers 0.47/250 - next line - R 17 G - next line H. I can't really explain any more, but I'm looking. Maybe someone can enlighten, Hailers, ?
Originally Posted by Digi7ech
^Stated a few posts above.
It's a small square box probably around the size of a dime. It has a small metal ring part to bolt onto something....
It's for the oil pressure sensor.
It's used for somethign like smoothing out EMI or something like that. That way your oil sensor reads correctly.
It's not absolutely needed but is recommened since all you have to do it screw it onto something like your bell housing or slave cylinder.
I'm lazy and never redid mine when I pulled my tranny. No adverse affects so far.
It's a small square box probably around the size of a dime. It has a small metal ring part to bolt onto something....
It's for the oil pressure sensor.
It's used for somethign like smoothing out EMI or something like that. That way your oil sensor reads correctly.
It's not absolutely needed but is recommened since all you have to do it screw it onto something like your bell housing or slave cylinder.
I'm lazy and never redid mine when I pulled my tranny. No adverse affects so far.
Not for EMI
This has been covered countless times...
#28
Former Moderator. RIP Icemark.
Originally Posted by Alex6969
funny that alot of us had no idea what it did. oh well it will be hooked up tomorrow.
question answered thread closed
question answered thread closed
https://www.rx7club.com/forum/showthread.php?t=476603
So I am not even sure why he is asking again.
And Mombo your reply was deleted for flaming again.
Thread closed on origintors request
Last edited by Icemark; 12-27-05 at 11:56 PM.
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM