Coolant Thermo Sensor
#1
FC4ME
Thread Starter
Join Date: Sep 2004
Location: Raleigh, NC
Posts: 1,079
Likes: 0
Received 0 Likes
on
0 Posts
Coolant Thermo Sensor
I recently had my car looked at because of the check engine light being on and was just told that my coolant thermo sensor was the problem. I dont happen to have a shop manual or Haynes manual handy so i was just wondering if someone could give me an idea as to where the piece is located and how hard/expensive it is to replace. Thankx. OH! and the car is a 90 N/A.
#2
Locust of the apocalypse
Join Date: Apr 2003
Location: Directly above the center of the earth (York, PA)
Posts: 2,553
Likes: 0
Received 1 Like
on
1 Post
Its the green connector on the back of the water pump housing to the left and below the altenator and beside the coolant line that runs to the BAC.
Not a big deal to change. Make sure you put some thread tape on the new one so that it seals up.
Not a big deal to change. Make sure you put some thread tape on the new one so that it seals up.
Thread
Thread Starter
Forum
Replies
Last Post
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM