Clutch sticks to the floor
#1
Stuck in the slow lane
Thread Starter
iTrader: (2)
Join Date: Oct 2008
Location: Riverside, CA
Posts: 358
Likes: 0
Received 0 Likes
on
0 Posts
Clutch sticks to the floor
just like it says my clutch pedel sticks to the floor when i put it in gear. It comes back up after a bit. I think i rounded it down to the clutch master or the slave or both. tell me what you guys think.
sorry if i misspelled.
sorry if i misspelled.
#2
NASA-MW ST4
iTrader: (7)
check your clutch fluid and bleed it, but its probably a dead master or slave.
When one goes out the other is not far away so replace both now. Get OEM units or you will be doing it again in a year or so. This is also the time to get a new connecting hose, you can get a stainless steel one from corksport for maybe $20.
When one goes out the other is not far away so replace both now. Get OEM units or you will be doing it again in a year or so. This is also the time to get a new connecting hose, you can get a stainless steel one from corksport for maybe $20.
#3
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Farberio is Right.Even if you replace on Piece of Hydraulic component(say the slave) then another one is apt to go Down the line.This is because you are Introducing a NEW part that can apply more pressure than the old part Could.,Result:failure of the Other part or parts.
The best solution is just Go and replace everything.The local parts Store can get you a clutch master and slave for roughly 120USD(tops).and I believe that Robert (FC3S91on forum) still sells the braided hoses.He is a Good seller.
The best solution is just Go and replace everything.The local parts Store can get you a clutch master and slave for roughly 120USD(tops).and I believe that Robert (FC3S91on forum) still sells the braided hoses.He is a Good seller.
#7
I
iTrader: (3)
check your clutch fluid and bleed it, but its probably a dead master or slave.
When one goes out the other is not far away so replace both now. Get OEM units or you will be doing it again in a year or so. This is also the time to get a new connecting hose, you can get a stainless steel one from corksport for maybe $20.
When one goes out the other is not far away so replace both now. Get OEM units or you will be doing it again in a year or so. This is also the time to get a new connecting hose, you can get a stainless steel one from corksport for maybe $20.
+2
i was gona give a long story but he/she sumed it up.
Trending Topics
#8
Stuck in the slow lane
Thread Starter
iTrader: (2)
Join Date: Oct 2008
Location: Riverside, CA
Posts: 358
Likes: 0
Received 0 Likes
on
0 Posts
I would rather not i can drive a little bit its just stoping thats where it all goes bad. Im just gonna fix it and go to the next one. better safe then sorry
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM