clearly stated, pilot bearing seal - which way to install?
#1
primitive screwhead
Thread Starter
Join Date: Feb 2003
Location: Boston, MA
Posts: 239
Likes: 0
Received 0 Likes
on
0 Posts
clearly stated, pilot bearing seal - which way to install?
The pilot bearing seal has a rubber side and metal side.
Which way does the rubber side go, towards the bearing or towards the transmission?
thanks
Which way does the rubber side go, towards the bearing or towards the transmission?
thanks
#5
Lives on the Forum
You need to pay attention to WHEN it's whining: clutch in, clutch out, etc. Many times guys have thought it was a pilot or throwout bearing making noise, when it's actually the tranny bearing(s) making the noise. If the clutch is out (disengaged), it's NOT the pilot or throwout bearings- neither are moving at that point (in the pilot bearing's case, relative to the tranny input shaft anyway), unless something is installed incorrectly.
#6
My Bick is Digger
iTrader: (3)
ah yes i did a lil search (duh) here we go. I think just having a good release bearing on my car made it whine more. I have a leaking speedo gear for a while now and may have run it low on fluid once or twice and I think that has affected my bearings inside the tranny mainly my input shaft bearing.
https://www.rx7club.com/showthread.p...=pilot+bearing
https://www.rx7club.com/showthread.p...=pilot+bearing
Thread
Thread Starter
Forum
Replies
Last Post