CAS Alignment
#1
Senior Member
Thread Starter
iTrader: (6)
Join Date: Mar 2001
Location: San Jose, CA
Posts: 444
Likes: 0
Received 0 Likes
on
0 Posts
CAS Alignment
Simple Question.
In the FSM, it says to line the pulley up to the yellow mark (which is 5* ATDC) and line up the dot and pointer on the CAS. After that insert into the front cover. Which is fine but what happens if you have a racing beat underdrive pulley and has marks in
10 ATDC , TDC , 10 BTDC , 20 BTDC
Should I worry or the 5 degree wont make a difference?
Insight?
Tommy
In the FSM, it says to line the pulley up to the yellow mark (which is 5* ATDC) and line up the dot and pointer on the CAS. After that insert into the front cover. Which is fine but what happens if you have a racing beat underdrive pulley and has marks in
10 ATDC , TDC , 10 BTDC , 20 BTDC
Should I worry or the 5 degree wont make a difference?
Insight?
Tommy
Last edited by GTR; 11-28-05 at 01:38 AM.
#4
Senior Member
Thread Starter
iTrader: (6)
Join Date: Mar 2001
Location: San Jose, CA
Posts: 444
Likes: 0
Received 0 Likes
on
0 Posts
LOL. I was about to do but I wanted to see if there was a different way.
Oh I saw your thread of your car running. Sounds like fun. I'm currently rebuilding mine. Hopefully all goes well to the both of us.
Oh I saw your thread of your car running. Sounds like fun. I'm currently rebuilding mine. Hopefully all goes well to the both of us.
Thread
Thread Starter
Forum
Replies
Last Post
Sammy Built
Haltech Forum
8
09-28-15 03:18 PM
erevos
2nd Generation Specific (1986-1992)
4
09-15-15 09:19 AM