Car will not start...flooding? no spark?
#1
Junior Member
Thread Starter
Join Date: Oct 2008
Location: tweeny twin twin
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Car will not start...flooding? no spark?
Ok here is a little back story, bought the car, had idle issues, previous owner had put in an MSD ignition, re-wired/cleaned up all that. Since then the car ran a bit rich, but that seems to be common.
moving on, it has had a bad warm start issue, it would normally start right up after sitting for some time, but no matter how long it ran, weather 1min or 30, after i shut it down it would not start at all.
This past week i replaced my brake master, and have not tried to start it since, and now, nothing, it seems like i am getting no spark, but at the same time i cant hear my fuel pump prime at all. there is a large quantity of fuel coming out of the exhaust as i crank, and it will sputter a little every once and awhile, but no signs of starting.
This is my first venture in the rotary world, so im as lost as could be.
moving on, it has had a bad warm start issue, it would normally start right up after sitting for some time, but no matter how long it ran, weather 1min or 30, after i shut it down it would not start at all.
This past week i replaced my brake master, and have not tried to start it since, and now, nothing, it seems like i am getting no spark, but at the same time i cant hear my fuel pump prime at all. there is a large quantity of fuel coming out of the exhaust as i crank, and it will sputter a little every once and awhile, but no signs of starting.
This is my first venture in the rotary world, so im as lost as could be.
#2
Moderator
iTrader: (1)
Read through the following linked thread below as it should provide you with info that is related to your problem. Check the Black/Yellow wire at the leading coil as stated in the linked thread and if it has battery voltage then make sure the coil(s) are mounted properly to the fender for if they are not they won't fire and if the B/Y wire has voltage then check the Green/Yellow wire at the leading coil as suggested in the linked thread. Do these things and tell us what happened.
Also make sure the Main relay clicks with key to on and that any of the Black/White wires connected to the emission solenoids or engine sensors has voltage w/key to on as well.
https://www.rx7club.com/2nd-generation-specific-1986-1992-17/done-everything-said-still-no-spark-help-916320/
Also make sure the Main relay clicks with key to on and that any of the Black/White wires connected to the emission solenoids or engine sensors has voltage w/key to on as well.
https://www.rx7club.com/2nd-generation-specific-1986-1992-17/done-everything-said-still-no-spark-help-916320/
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM