Can't get my aux port actuators off
#1
Sewww Speciellllllll
Thread Starter
Join Date: May 2006
Location: Richmond, BC
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
Can't get my aux port actuators off
It should only be those two nuts, then I can slide the actuator off right? Ain't working for me, anyone got any suggestions?
#2
Senior Member
Join Date: Feb 2007
Location: Rock Hill, South Carolina?
Posts: 316
Likes: 0
Received 1 Like
on
1 Post
Your ports look like they are seized open so there is tension on the piston and the black linkage on the actuator rod and this is probally causing it to jam. You need to try to wiggle it off.
The only other problem could be that corrosion has caused the holes and studs to seize. For this you would need to spray with lots of WD-40 type product and try to tap it loose.
GOOD LUCK getting that phillips screw out after you get the vacuum/pressure solenoid off. I had to grind the heads off with a dremel because the cheap *** screw heads strip out.
The only other problem could be that corrosion has caused the holes and studs to seize. For this you would need to spray with lots of WD-40 type product and try to tap it loose.
GOOD LUCK getting that phillips screw out after you get the vacuum/pressure solenoid off. I had to grind the heads off with a dremel because the cheap *** screw heads strip out.
#5
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Dude,,just Tap the Bell shaped outside diaphragm.IF you have got the Two Ten mm Nuts off,there is nothing but the Old gasket holding it on.Once it gets a little Loose,wriggle it back and forth ..It may be stuck on that little Hinged part Of the pin too,so Just make sure that is OK,and it should just come off...
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
alexdimen
3rd Generation Specific (1993-2002)
20
10-23-15 01:50 PM