Can i use manifold
#1
Full Member
Thread Starter
Join Date: Mar 2002
Location: Grand forks
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Can i use manifold
i have an 88 TII my manifold is the one on the left with the little hole on the upper left i just got the one on the right this one has no hole and it has a flapper inside.
if i remove the flapper will this manifold work? is it possible to have a machine shop drill the hole in it.
Do i have to have the little hole?
if i remove the flapper will this manifold work? is it possible to have a machine shop drill the hole in it.
Do i have to have the little hole?
#3
Full Member
Thread Starter
Join Date: Mar 2002
Location: Grand forks
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
yea i cant get the pic small enuff to fit
is there anyone that knows what im talking about
my old manifold has a extra hole and no flapper
the new one does not have the extra hole and it also has a flapper in the right exhaust hole.
So if you are looking at the engine block there is a third exhaust port on the lower left.
is there anyone that knows what im talking about
my old manifold has a extra hole and no flapper
the new one does not have the extra hole and it also has a flapper in the right exhaust hole.
So if you are looking at the engine block there is a third exhaust port on the lower left.
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM